Error updating locale 7961

It already has the SIP firmware loaded (SIP11.8-4-1S) and theoretically all that should be required is the SEP(mac address)xml file and This may give you an idea when applied to your 7911 /forum-replies.cfm?

At present the phone is stuck in a "Registering" state and the following items are logged in Status Messages: Error Updating Locale Error Updating Locale DNS Unknown Host DNS Unknown Host On researching the "Error Updating Locale" error I found the following: --------------8 Believe beneboi mentioned a similar issue on a 7975 that however went away once his NAT traversal and port forwarding were sorted. t=1390896 Assuming 7911 has settings for those, what is the voipcontrolport set to? t=1390896&p=6#r113 Have never configed a 7911 SIP, can you post the config minus personal details? This may give you an idea when applied to your 7911 /forum-replies.cfm?

Docs suck too, everything is based off SOHO or SMB. Switchvox Free version needs the phone to do all the configuring and then it just logs into the PBX.

My phones are stuck at the registering state and i have tried turning off NAT in the ext settings and in my config file...could use an example config or something.Figure 7.1 illustrates how the Cisco IP phone acts as a three-port switch.With IP phones residing in a separate VLAN—a voice VLAN—it is easier for you to automate the process of deploying IP phones.On top of that, to get the phones to even work right you have to use very specific versions of the SIP firmware as the phones are not designed to work with third-party phone systems that talk generic SIP messages.While I can tell you that Cisco recommends using SIP firmware 8.3.2 SR1S, I cannot provide the firmware files because of their licensing agreements.

Leave a Reply